SAMDO Universal Fuel Gauge Digital Fuel Level Gauge Marine Fuel Meter Full Waterproof Signal Adjustable 7 Color Backlight 52mm 12V/24V 0-190ohm, 240-33ohm, 240-30ohm, 0-180ohm, 10-180ohm

works well

Works great, easy to install and program. Time will tell how it holds up. Bright and easy to see day or night.

I have been reading that there has been a problem with this item. When I turn it on it goes to a blinking yellow light. I expect that it needs to be exchanged. Please let me know the procedure?

replace dash on an RV with 3 of these type, works good, looks good.

I have reviewed this gauge with two or three other gauges they all work well. This gauges made of high quality and is pretty darn accurate. Fast shipping and I would recommend and I would repurchase

I installed this in my John Deere F932 lawn mower. JD wanted $150 for a factory one and used ones were around $90 online. The installation instructions for setting the resistance range were fairy easy to follow. I used my multimeter to measure the resistance range of my sending unit when empty and full (about 8 and 184 ohms in my case). So I selected the 10-180 ohm range. You press and hold the mode button for 3 seconds or so to put it into setup mode. The backlight will begin to flash. Then you press and release the mode button as needed until the needle points to the fill mark on the gauge that corresponds to the ohms range as illustrated in the instructions. In my case I had to press and release a couple times until the needle point to the half full mark, which corresponds to 10-180 ohms. Once set, power down the unit and you are done. It has like 6 different back light colors you can set as well, but I didn't mess with it. I left it the default red.

I installed this gauge and I never registered over 1/4 tank. I rewired and eventually installed a new sending unit but nothing helped. I finally took my boat to a shop and they pulled the gauge, bench tested it, and discovered it was bad. Too late to return do to dicking around with everything else I thought was the issue. I'm out $25 for this gauge and $92 for the new gauge the shop installed. Ughhh...

Had to find a video online to understand calibration instructions. Plenty of lead wire length to facilitate connections, though the gauge wire was couple of sizes smaller than wiring in the boat.Do multiple operations checks before you tighten it down.Installation looks good.

Works good. Looks good Easy to install Like that it’s programmable to match the resistance of various sending units.

Works great , and is easy to install. It took a bit of working with to get it reading properly, but now works a little to good. When it shows empty it's empty and I had to walk back to the house

bon

Great work well

bon produit