Krytox D10170965 Grease, 0.5 kg/1.1 lb. Jar

Quality grease, used for lubing motorized stage light fixtures.

The product arrived on time and works as expected. Good quality for the price.

Fantastic grease for O rings and rubber seals because I never have to worry about the rubber composition, works with everything. I also use this on the FEP film in my resin printer bed, it is also fluorinated. I smear a small 2mm drop all over the FEP with my finger and then wipe out all the excess with a microfiber cloth. Have had Zero failed prints since and the vat dumps out really fast since the liquid resin doesn't stick. Works much better than the dry film teflon spray people recommend. I can even tension the film very tight and the prints still don't stick. But You have to be very vigilant on keeping dust out or you have to wipe it out again, you can't easily blow the dust out with that very thin coating of grease on there.

Puchased to quiet up the aging rubber seals on my older BMW. Worked well, but I had to ration it to get all four doors done.

Very easy to apply, it does the job

Got some to do some WAY overdue maintenance on my 3D printer, and didn't have the little tubes it came with. Grabbed this as I figure if I'm gonna do it, I go all the way. These devices need precision movement, and I wasn't going to take chances seeing as this device had been unused and unmaintained for over a year. Put on a pair of nitrile gloves, and worked this all into the threads and rods for the bot movement. Ran off a print with some fairly precise movement requirement and it came out perfecty, the print heads slide like butter over the rails and the Z-axis movement with the threaded rod was like new. No complaints at all, and this tube should last me a couple of years at least of maintenence.

Completely stopped the squeaks in my power sunroof weather strips.

Applied well, easily obtained from the tube, clean, very easy to clean up after applying. Too early to state long term benefits, but the several studies show that it is clearly superior to other lubricants in high stress/high binding areas. Just very expensive even though the amount in the tube easily covered the lubrication of the Honda NT700V drive shaft, and drive line components with large amount left over. According to studies I have read, I will never have to lubricate the drive shaft or its components again, but this has to be proven. Will be nice not to have to do the process every 12,000 miles.

good